| 96 INCH CARBON STEEL HOPPER SPREADER W/ EXTENDED LENGTH SPINNER AND CHUTE ASSEMBLY IDEAL FOR MEDIUM AND HEAVY DUTY COMMERCIAL APPLICATIONS.
General – All hopper spreaders are completely self-contained,ultra--durable spreader units designed for ice and snow control.The rugged design allows for use with salt, sand and other materials. The complete assembly mounts easily on pickup, dump and platform trucks making it ideal for municipalities,shopping malls,industries,hospitals and private contractors.
MATERIAL HOPPER – Electrically welded 12-gauge ends and steel sides sloped at 45 degrees are constructed with channel formed top edges. Each side of the hopper has two 12-guage vertical supports to add extra strength to the unit. The single lift point on the cross support beam is located at the unit ’s center of gravity to allow for easy loading and unloading. The floor is constructed of 10-gauge steel.
CONVEYOR – The conveyor is made of 12 inch wide all-steel pintle chain with 3/16 inch x 3/4 inch cross bars. Chain strength is 11,000 lbs.per strand;22,000 lbs. total weight. The drive sprockets are 6-foot cast iron, on a 1-1/8 inch diameter shaft. The conveyor chain has an adjustment range of 3-1/2 inch . The drive shaft has heavy-duty, sealed, self-aligning ball bearings with grease fittings. The idler drum has heavy-duty 1 inch diameter ball bearings.
CONVEYOR GEAR CASE – Gear is constructed of aluminum bronze, worm gear is hardened steel and ground. Housing is made of durable cast iron. Gear ratio is 20:1 with 1 inch input shaft and 1-1/8 inch output shaft on tapered roller bearings.
FEEDGATE – Lever operated with a friction lock for accurate adjustment.
SPINNER CHUTE ASSEMBLY – A polymer disc with four fins is connected to a 3/4 inch diameter shaft secured on two pillow block bearings. The spreading material is guided from the conveyor to the spinner plate through an enclosed 12-gauge chute with internal and external deflectors. Adjustable deflectors allow for complete directional spread control and full or compact spread. Total spread radius ranges from 2 ft. to 25 ft. . The extra wide rear deflector protects the rear and under carriage of the vehicle.
ENGINE – Heavy-duty 10 horsepower Tecumseh engine. Engine comes equipped with alternator and 12 volt electric starter with incab start/stop and electric throttle control (standard). Entire engine is completely protected by the convenient hinged hood.
ELECTRIC THROTTLE CONTROL – Throttle control unit allows for full-range of throttle settings,including idle and full choke,via the in-cab hopper control box. Use of electric throttle control eliminates cable freezing,binding and breaking.
CLUTCH – 12 volt DC electric clutch has a three-position in-cab switch, for greater control and material economy. Also allows for low speed operation and spot spreading.
Stainless steel models feature high-quality grade 304 stainless steel components, including: Hopper, Hopper Supports, Hopper Floor, Gussets, Spinner Chute Assembly, Deflectors and Engine Hood. Body Side Length, 8 ft. ; Overall Length, 113 inches Weight-Carbon Steel, 820 lbs.; Weight-Stainless Steel, 625; Capacity Struck, 1.8 cu.yd.; Capacity Rounded, 2.1 cu.yd.; Width, 50-3/4 inches ; Height, 32 –1/2 inches; Recommended Use, 3/4 or 1-Ton Trucks. | 
