| MOLDED POLYETHYLENE HOPPER SPREADER W/ STAINLESS STEEL SPINNER ASSY.
IDEAL FOR MEDIUM AND HEAVY DUTY COMMERCIAL APPLICATIONS.
General –The SHPE1500 series Salt Dogg spreaders are completely self-contained, ultra-durable spreader units designed for ice and snow control. The rugged design allows for use with salt or salt/sand mix. The complete assembly mounts easily on pickup, dump and platform trucks, making it ideal for municipalities, shopping malls, industries, hospitals and private contractors.
MATERIAL HOPPER – Rotationally molded polymer unibody spreader with sides sloped at 45 degree angles to maximize material flow. Features integrated positive position mount system plus 4-piece ratchet tie-down kit. No drilling required. Molded fork slots in hopper make for easy one man installation and removal (requires extended forks).
AUGER – Screw-type auger system travels the length of the hopper floor, providing maximum material flow at a continuous rate. An independent spinner/auger controller allows for both independent spinner speed and an infinitely adjustable ratio between spinner and auger.
MATERIAL FLOW/OUTPUT – Salt, 2.2 cu. ft. / minute; Salt-Sand, 1.3 cu. ft. / minute. Spread width is variable from 5 to 38 feet.
SPINNER CHUTE ASSEMBLY – An 11.5 inch polymer disc with four fins is connected to a 3/4 inch diameter shaft. The spreading material is guided to a 3/4 inch diameter shaft. The spreading material is guided from the stainless steel trough to the spinner plate through an enclosed heavy-duty stainless steel/poly chute and spinner assembly with an external deflector. The adjustable deflector allows for complete directional spread control and full or compact spread. The extra-wide adjustable deflector protects the rear and under carriage of the vehicle, and allows for complete directional spread control and full or compact spread. A convenient spring-latch locking mechanism allows the spinner assembly to be easily removed for cleaning/storage.
ELECTRIC MOTORS – Two ultra-quiet 12-volt DC direct-drive motors power the auger and spinner, and are protected in a stainless steel housing along with the independently powered vibrator. The wiring harness is constructed of 10-gauge automotive wire with non-combustible sheathing (-50 degree to -105degree C). An in-cab console features independent controls for the auger, spinner and vibrator.
STANDARD EQUIPMENT – 1/4 inch black powder coated steel top screen with 1.5 inch x 1.63 inch grid pattern. Heavy-duty poly-vinyl tarp with reinforced corners and tie-down kit. Heavy-duty 12 VDC vibrator, rated at 210 foot pounds for maximum performance. Spreader hold-down kit. Overall Length, 92 inch (requires 77 inch minimum bed length. Fits all 8 ft. beds and most standard 6 ft. beds); Capacity Struck, 1.45 cu. yd.; Width, 50.5 inch ; Height, 37.5 inch ; Recommended use, 3/4 or 1-Ton trucks. | 
