Click to enlarge

BASIC UNIT	OPTIONS
30,000 LB LIFT  119” Reach  Minimum Wheelbase 250”  Double Frame Recommended  Power Elevation/ Extension/Tilt  4 Sets of Forks(low front, high front, back  axle &chain)  Tie Down Chains  Underlift height level 36”  Underlift height tilted & retracted 72”  Underlift height tilted @ full extension 90”  Positive tilt 25 ° Negative tilt 15°  Underlift length retracted 72”	Wet Kit  Remote Control  15-25,000 LB Winch Packages   Wheel Lift Attachment  Spring Fork  Pony Motor/Hydraulic Kit  Removable Receiver  Spade Attachment  Installation  Truck Mounted Wet Kit

FEATURES:  

·          ‘Grease free’ sealed bearing for the underlift Roller   

·          Fits INSIDE the frame in the back(cannot be knocked sideways off the back of the frame)   

·          Has the ability to sit CLOSER to the rear end of your tractor than ANY other unit on the market   

·          3^rd guide pin on the front of the frame mounted receiver for quicker hookup   

·          Underlift can be used as hydraulic stiff leg with optional spade attachment   

·          Cross tube on the T-bar is 4X4 for easier hookup under low bumpers and series 60 oil pans   

·          Controls, while normally mounted on the Driver’s side, can be ordered with Passenger side controls (one side only) at no additional cost   

·          Built-in brackets for toolboxes  ·          Aluminum fenders. ·         *  Paint – Platinum Color Epoxy Primer

 PICTURES BELOW ARE OF UNIT BY ITSELF AND INSTALLED ON MISC CHASSIS.